BD Hybrid & Electric Series
Video
High precision and consistent injection phase with shot weight repeatability lower than 0,09%. The two-column guide ensures a perfectly tight nozzle contact. The plasticizing takes place simultaneously with the other movements, allowing a significant reduction in cycle times. Injection unit supported by high precision prismatic guides.
- Electric direct drive on injection, electric plasticizing
- High precision and high response pressure sensor
- Wear-resistant barrel
- Chrome-plated screw
- Open type nozzle
- Different screw size available
- Hydraulic carriage (Hybrid series)
- Injection unit movement control mode
- Nozzle centering calibration
- Linear guide for nozzle movement
- Movable hopper sliding device
- High power ceramic heating band
- Nozzle safety guard with electric lock
- High pressure/temperature tube for cooling ring of hooper throat
- Double insulation cover for barrel
- Low pressure/speed movement control under setup mode
- Prevent overfilling function
- Injection curve monitoring function
- Injection speed response adjustable
- Injection pressure control mode
- Multiple V/P switches via combination of position, pressure and time
- Injection-compression function
- Parallel plasticizing function
- Intrusion function
- Auto purge function
- Suck back function
- PID temperature control on nozzle
- PID temperature control on barrel
- Screw cold start prevention
- Timing heating function
- Temperature optimization function
- 6 stages injection control, pressure /speed adjustable
- 5 stages holding control, pressure /speed adjustable
- 5 stages plasticizing control, back pressure /speed adjustable
- 4 ways of nozzle backward
- Temperature monitor of feeding zone
- Temperature monitor of shaft bearing
- Screw rotation speed setting and display
- Injection pressure calibration function
- Real-time injection pressure display function
- Real-time plasticizing back pressure display function
- 1 valve gate on program
- 1 doser signal on program
- Antivibration pads
Innovative design of low impendance and low inertia clamping unit. No contact between the moving platen and the upper tie bars, the movable platen slides on high precisionprismatic guides.This allows high-speed movements with perfect parallelism. The servo motor/clamping unit direct drive significantly increases the closing/opening speed of the toggle compared to the belt drive system.
- Electric direct drive mold movement
- Double 5-point toggle locking system
- Mold platen with T-slot and mounting holes
- Center - lock clamping unit
- High-rigidity fixed platen
- Linear guide under the moving platen
- Independent location ring for fixed platen
- Hard chrome plated tie bar
- Ejection two-parallel-cylinders
- Cooper bush guide for ejector platen
- Quick change coupling for center platen
- 3 modes of control for ejector
- Adjustable ejector backward confirmation switch
- Centralized lubrication system with end sensor
- Top cover on clamping area (≤200T)
- Lubrication oil tray under moving platen
- Robot mounting holes
- Hydraulic mold adjustment
- Mold adjustment with limit protection
- Auto clamping force adjustment
- Auto mold height adjustment
- High pressure release function
- 5 stages of mold closing, pressure/speed adjustable
- 5 stages of mold opening, pressure/speed adjustable
- 3 stages of ejector control, pressure/speed adjustable
- 2 sets air blow signal without valve
- 2 sets core puller signal without valve
- Ejector function
- Adjustable mold area lighting function
- Product drop chute (90T-240T)
- Ejection during mold opening
- Low pressure mold safety protection
- Vacuum recycling function
- Opening and closing mode signal
- Flowmeter